Two-compound research blend

Wolverine Blend

BPC-157 + TB-500 fragment

Not FDA-approved

A marketing nickname for a blend of BPC-157 and a thymosin beta-4 fragment. A nickname does not turn two experimental substances into a validated therapy.

FULL RESEARCH GRAPHIC

Wolverine Blend research overview

A dedicated overview of the 20 mg BPC-157 and TB-500 blend and its recovery-focused research context.

Cybertide Wolverine Blend 20 mg research infographic for BPC-157 and TB-500

Tap the graphic to open the full-resolution version.

CYBERTIDE // VISUAL PROFILEWolverine Blend
PROFILE07
IDENTITYBPC-157 + TB-500 fragmentTwo-compound research blend

RESEARCH SIGNAL MAP

04 ACTIVE FIELDS
NODE 01Preclinical tissue models
NODE 02Angiogenesis pathways
NODE 03Inflammation signaling
NODE 04Peptide characterization

EVIDENCE READOUT

Not FDA-approved

Claims about tendon, ligament, muscle, gut, and whole-body healing substantially outrun controlled human evidence.

BOUNDARY CHECK

CONTEXT REQUIRED

FDA reports limited or absent human safety information and potential immunogenicity and impurity concerns for both components.

RESEARCH CONTEXT • PRIMARY SOURCE LINKED • QR READYSOURCE ↗

SUBMITTED LAB DOCUMENTS

Test results

Reports may describe other strengths or blends. Match the labeled amount, composition, and exact lot to your vial. A report for another strength does not verify your vial. Each record identifies whether an exact lot was supplied.

VIAL REFERENCE

3 mL mixing math & dosing context

Every number is labeled by evidence level. The 3 mL reference calculates concentration and U-100 volume; it does not prove solvent compatibility, sterility, stability, or suitability for injection.

VIAL STRENGTH

20 mg total (BPC-157 10 mg + TB-500 fragment 10 mg)

AFTER 3.0 mL6.67 mg/mL0.07 mg per U-100 unit

At 3 mL, each component is 3.33 mg/mL; the combined concentration is 6.67 mg/mL.

AMOUNTVOLUMEU-100
500 mcg0.07 mL7.5 units
1 mg0.15 mL15 units
2 mg0.3 mL30 units
LIVE CALCULATOR

Change the liquid. See the amount.

U-100
CONCENTRATION6.667 mg/mL
DRAW VOLUME0.1 mL
AMOUNT IN THAT DRAW0.667 mg666.7 mcg

Calculation only: vial amount ÷ liquid volume × draw volume. It does not determine what dose to use or confirm product compatibility.

01 / MIXING REFERENCE

3.0 mL BAC-water workflow

  1. First confirm that bacteriostatic water and a 3.0 mL final volume are compatible with the exact product and vial capacity.
  2. Clean both vial stoppers with alcohol and allow them to dry.
  3. Add the 3.0 mL slowly down the inside wall instead of directing pressure onto the powder.
  4. Gently roll or swirl until dissolved; do not shake.
  5. Use product-specific refrigeration and discard guidance. If none exists, do not invent a beyond-use date.
NO ESTABLISHED HUMAN GUIDELINE

No controlled human dose for the blend

No controlled human trial establishes a dose, frequency, cycle length, or combined-injection protocol for this two-compound blend. The conversion table is vial math, not a treatment recommendation.

FDA — compounding safety risks ↗

U-100 means 100 units = 1.0 mL. Any table result above 100 units exceeds one standard 1 mL U-100 syringe.

PRIMARY CONTEXTFDA — compounding safety risks
Open source ↗
NEXT INFOGRAPHICSemax →